Bonsai teaching: the method of bending the trunk of bonsai branches is different.

One. Pea potted plant

Pea potted plants are small and easy to show the characteristics of the tree, but they can usually show the first bend of the root, and the impression of the tree will be interesting, and then use some branches, the whole tree is durable, unless it is. Cultivated straight or plural. The turning point of the tree is a lesson in cultivating potted beans. Of course, corners also require some skill and sensitivity.

When the diameter of the two branches is less than 1.5 cm

First, place the linen on the outer edge of the curved surface, and then wrap the hemp tightly around the curved part to enhance toughness and prevent fracture.

The tree is so mediocre that its thickness has not changed. We must work hard to succeed. Because the bones on the torso have been produced for more than 20 years, they are easy to break when bent. The following is done: the first step is to bend and wrap around the torso. The flax must be tightly wrapped and covered with a groove.

After wrapping the marijuana, four 5mm aluminum wires are fixed on the outside. As mentioned above, the wire is tied to the flax wire. Tie 4 pieces of aluminum wire.

Tie four aluminum wires with one small aluminum wire. Take the result at the end of the bend. When you bend over, lift the crown and close the trunk. Be careful and slow when bending over. The whole process did not hear the sound of dry crack. After bending, the torso has undergone some changes and development.

After the trees are restored, the branches and leaves need to be reformed. The prerequisite for bending is to do everything possible to protect the branches that need to be bent.

three. A thicker trunk greater than 1.6 cm in diameter

Trunks larger than 1.6 cm in diameter need to cut a longitudinal groove on the outer edge of the arc, up to 2% of the xylem. The thicker the branch, the larger the longitudinal groove, the thicker the bark, and finally the upper part of the torso connects together. The box is equipped with nylon rope or brown rope and lead wire. If the torso is rough and hard, a sharp knife can make a longitudinal cut of about 4cm and 5cm at the bend of the branch when it is difficult to bend. The depth can penetrate the torso, then combine with the skin, and then with a thicker lead or brown wire, so that the torso is not easy to break when bent. In addition, the thick and straight branches can reach the pulp segment in the bending position, and L 2 pieces can be taken out to make the internal gap, twist and twist the branches. Usually in the opposite part of the knife on each side, if the branch is very thick, it can be divided into three parts, and then add a knife, the brown silk wrapped in the skin can be slowly twisted to a predetermined angle and bound. This method should be considered in advance and cannot be concluded. Slotted lining is safer