Why do honeysuckle leaves curl down? What about honeysuckle leaves?

What is the curl of honeysuckle leaves? Is there anything you can do? Let's take a look.

First, the disinfestation is not timely: if the raw aphids are not treated in time, the aphids can be prevented by a small dose, and they will not be burned to death because of the medication, and the dosage does not have to be too large.

Second, lack of water: take too many branches and leaves, branches and leaves need more water, coupled with the newly transplanted seedlings, too many branches and leaves lead to insufficient water supply

Third, the soil does not store water: after the middle and lower reaches, the root soil may not be firm, resulting in soft root soil, easy to lack of water, and your Gansu side is relatively dry. Wind and sand should not be the main reason, but the wind is easy to make the soil drier, honeysuckle does not have high requirements for soil nutrients, and newly planted seedlings may not be able to absorb even if they apply base fertilizer. It is recommended to cut off the branches and leaves properly, especially those that have been dried to death, but do not cut too much, just remove the dead branches. You can stabilize the soil.

After problems are found, it is suggested that the flowerpots and soil should be rectified:

First, the cultivation substrate: although honeysuckle is not strict with the soil, the plant will grow better when the mixture of 60%-70% peat, 20%-30% vermiculite and 10% perlite is used as the culture soil.

Second, water and fertilizer management: during the three months before flowering, fertilizers mainly composed of phosphorus and potassium were applied twice. After the flowers withered in late May, thin fertilizer should be applied twice and the new shoots should be properly coring so as to promote the germination of the second batch of flower buds. At the same time, the soil should remain moist and avoid being too dry, otherwise the basal leaves are easy to wither, yellow and fall off and affect flowering. In the hot season, avoid the bright light so as not to burn the tender leaves.

Third, plastic pruning: a pruning is carried out during dormancy to cut off the slender branches, weak branches and cross branches, and to truncate the current year's branches, so as to promote new branches and bloom more in the second year.

Fourth, pest control: honeysuckle diseases and insect pests are relatively few, occasionally attacked by aphids, harm new leaves, tender shoots, make leaves roll up, affect growth, only need to use "aphid lice" 1000 times liquid or other insecticides to control.