Do succulent plants propagate and not sprout? Teach you to choose healthy leaves to easily root and sprout.

Fleshy plant leaf propagation is often said by flower friends to be fleshy leaf insertion, but also a common method of fleshy reproduction. There will always be some unsatisfactory conditions in the process of leaf insertion, among which only roots do not sprout, only germination does not sprout roots is the most troublesome. For the success of leaf cutting, the key role is the selection of healthy mother leaves. Choosing a healthy and complete mother leaf can reduce a lot of trouble for subsequent leaf cutting maintenance.

Succulent plants should choose succulent plants that grow very strong, pick leaves, take off succulent leaves, can be used directly, be careful not to pick leaves immediately after watering, wait for them to dry slightly, so that leaves will be easier to pick off. It's important to look at fleshy leaves, and there's a lot of information that can be gleaned from fleshy leaves.

Very healthy fleshy, leaves are very stiff, there are growth points. The leaves of mature succulent plants wither, and the state still does not recover after 2-3 days of watering. In this way, it can be concluded that the root system has not grown well. Under the condition that the root system is not much, the succulent absorption will be very poor. Even if there is enough water in the soil, it cannot be absorbed. At this time, you can further analyze your soil mix. If there is no problem with soil mix, wait. Do not have doubts and pull out the succulent for inspection. The succulent growth is relatively slow. Therefore, the recovery speed will also be very slow. If the cutting state is not good like this, the meat will change after about 3 months. Of course, the temperature must exceed 15 degrees, otherwise the recovery time will be longer.

A succulent plant can be torn off from its poorly growing leaves at the bottom, and small shoots can sprout from the torn off wound. If your succulent plants are beginning to rot, don't hesitate to remove the parts that are beginning to rot. After a while, lateral buds will appear in these areas. Some succulent plants suitable for leaf insertion in the soil growth is better, select out and insert in the prepared soil to cultivate soil must choose suitable soil sand for this plant, gently insert the succulent roots directly, to insert a little shallow, that is, the leaves just can stand obliquely on the line.

Leaf cuttings reproduce succulent plants, and when roots grow out of the leaves, you can start watering them appropriately. At this time, you can use tools such as chopsticks to dig a shallow pit in the soil, put the newly issued roots in, and gently spread a layer of soil to cover it. And then the new life grows up. The most important factor affecting the success rate is the blade itself. Choosing healthy leaves represents a much higher success rate. Depending on the variety, the time and success rate of leaf rooting and budding will vary.

Many friends do not know how to deal with the late leaf insertion, generally in 20-30 days or so can see the bud. Some varieties will be slower, do not worry, if two months do not sprout roots, or leaves transparent, or only root does not sprout, basically declared that the leaf failed. When the leaves appear roots can be gently buried in the soil, continue to wait until the sprouts appear, and then grow about a week can be moved to the pot with other seedlings as normal care.

This is a gathering place for succulent plant lovers to share succulent conservation skills. Welcome to pay attention to communication.