MySheen

Installation code for excellent planners and electricians the depth of pipe hinge teeth should be moderate and free of burrs.

Published: 2024-12-18 Author: mysheen
Last Updated: 2024/12/18, 1. The principle of wiring: horizontal, horizontal and vertical. Using special PVC flame retardant wire pipe, the wire pipe must be fixed in the wire slot, the lock mother should be used when the wire box is connected with the wire tube, a pipe card should be used every 80 cm, and every 20 cm at the corner.

1. The principle of wiring: horizontal, horizontal and vertical. Using special PVC flame retardant wire pipe, the wire pipe must be fixed in the wire slot, the lock mother should be used when the wire box is connected with the wire tube, one pipe card should be used every 80 centimeters in the straight pipe, and one pipe card should be used every 20 centimeters at the corner.

2. The socket is in the upper part of the wall, slotted vertically upward on the wall, and installed in the installation line of the decorative corner line at the top of the wall. If it is in the lower part of the wall, it is slotted down vertically to the bottom of the installation baseboard, and the slotting depth should be the same. The slotting line and top straight should first pop up the control line on the wall, and then cut the wall with a cutting machine and slotting with a machine.

3. When using PVC pipe, use spring to bend the pipe, do not use 90 degree elbow and tee, the line must be protected and connected with glue, and the edge of the casing should be closely connected. Straight and straight. Smooth. The inside of the right corner should be cut, and one side of the cut should be bent and installed after the circular arc joint on one side of the cut.

4. The depth of the pipe tooth is moderate and there is no burr. The pipe joint is wrapped with raw material tape for 5-6 times, and the number of pipe teeth is 5-6 teeth, until the joint is tightened and rotten teeth are not allowed to enter the tube.

 
0