MySheen

How do plants and flowers reproduce in pots? In this way, you can change one basin into two or even hundreds of pots.

Published: 2024-11-24 Author: mysheen
Last Updated: 2024/11/24, How do plants and flowers reproduce in pots? In this way, you can change a pot into two pots or even hundreds of pots of flowers commonly used to breed. I raise plants in one pot to become more than one pot depends on this secret. There are two methods of flower reproduction. ...

How do plants and flowers reproduce in pots? In this way, you can change one basin into two or even hundreds of pots.

There are two commonly used methods for flower reproduction. I raise plants in one pot to become more than one pot depends on this secret.

There are two ways to reproduce flowers.

One is the sowing method, good seeds can play a key role in the reproduction of flowers, sowing and reproduction need to do the following to ensure the good reproduction of flowers.

Harvest seeds

Mature seeds are needed to grow healthy and healthy flowers, so it is important to harvest flower seeds. If the seeds are harvested too early and the nutrients stored in the seeds are not enough, healthy flowers will not grow. When the seeds mature, the petals become dry, and the seeds are solid and shiny. Storage of seeds:

After harvest, the seeds should be threshed, air-dried, and sundries removed in time, and then the clean, full, disease-free and pest-free seeds should be selected. Dry slowly, not in strong direct sunlight. Seal it in a container and store it in a cool, dry place.

Sowing and management seeds-seeds that are mature, full, easily germinated, good varieties and free from diseases and insect pests should be selected for sowing. Sowing time should be determined according to the florescence, generally there is no special seasonal limit.

The sowing method is often used, that is, the seeds are scattered evenly on the soil. At the same time, the soil should be covered thinly, and then sprinkle water to keep the soil moist, but not too much watering, otherwise the seeds will rot, but not too little, which is not conducive to seed germination. In addition, there is also a bit of sowing method, that is, sowing according to a certain plant spacing and row spacing, sowing 2-3 seeds in each hole, only one strong seedling is left in a pot after germination and growth, and the rest is removed. After sowing, always check the degree of wetness and looseness of the soil, and water and loosen the soil in time. After the seeds germinate, according to the water demand of flower buds, the times of watering are gradually reduced.

Ramet breeding method

The method of split-plant reproduction refers to the method of dividing the rhizome and corm of flowers from the mother plant and planting them into independent new plants.

There are also two methods of ramet propagation:

Total method

The total method is that the quat flowers are dug up from the soil with roots, and then divided into several small clumps, which are planted in other flowerpots.

Half method

The half method means that instead of digging up all the flowers, only dig out the soil on both sides or one side of the mother plant, cut out several small clumps with roots with scissors, and transplant these clumps to other places to become new plants.

 
0