How to grow flowers when the balcony is too small? A pipe bends a wire and makes a three-dimensional flower rack.

Three-dimensional flower rack 1

Photo source: corporate dad

Production steps:

1. Prepare PVC pipe for drilling

Go to the hardware market and buy a PVC tube with a diameter of about 110cm and a diameter of about 7cm.

2. Punch holes

On the pvc pipe, punch the hole at the interval of 20cm. If you want to do the two-sided one, punch two holes and four holes if you want to do the four-sided one. Today, four holes are punched, and the front and rear holes and the left and right holes are not on the same horizontal plane.

3. Bending of iron wire

Bend the wire prepared in advance into an iron ring, and the diameter of the bend is determined according to the size of your own flowerpot, do not use too thin wire, otherwise it is easy to deform.

4. Insert the iron ring into the pvc pipe

Insert the bent iron ring into the PVC pipe in turn, bend the protruding part through the hole, and then fasten it with something like wire to prevent the ring from shaking.

5. PVC tube fixation

Seal the bottom of the PVC pipe, first pour into the sand of about 1x4, insert it into the flowerpot, fill the soil and let the soil dry, so that it is stronger.

If there is a discarded clothes hanger base at home, you can also fix the PVC tube on the base of the triangle hanger, which can also enhance the stability and prevent the tube from askew after putting on the flowerpot.

6. PVC tube fixation

In this way, a three-dimensional flower rack will be done! Put the flowerpots you want to place one by one, and you're done! But it needs to be turned every few days to prevent flowers from receiving uneven light.

Three-dimensional flower rack 2

Photo: the balcony is a little sweet.

Production steps:

1. Prepare the pvc tube

If there is no iron wire at home, you can also use pvc pipe directly. First prepare a pvc pipe with a length of at least 1m.

2. Scribing sawing

At the place where the 10cm is separated from the pvc pipe, draw the line separately, and then saw the underlined part with a saw.

3. Fire pressing

After sawing, bake it a little bit over fire, then take another pipe and press it down along the sawing place to form a groove.

4. Seal the bottom

Seal the bottom of the pvc tube thoroughly, so that a three-dimensional flower rack will be done!

5. Fill soil to plant vegetables and flowers

Finally, fill the soil into the pipe and plant the flowers and plants or green vegetables, even if it is done!

In addition to the introduction above, there are actually a lot of self-made flower racks, which do not take up space and are good for growing flowers. Come and have a look!

Read the introduction of Huahua.

Are you all attracted to each other?

You flower friends might as well try it yourself.