How does Margaret change the basin?
Change the big basin
1. If you take the plant out of the pot, you will see that the roots are intertwined, and you can hardly see the soil.
2. In order to make it grow again, the hardened part of the root needs to be gently ripped off, and then it can be planted. If the root is not aging and sparse, it is not necessary to do so.
3. Put the prepared nutritious soil in 1/3 position in the basin.
4. Next, you can put the prepared plant into the soil, fill it with soil, and ensure that there is no gap around it. At this time, you can press it slightly with a small stick.
5, after planting it, you can press it hard with your hands, remember not to let the soil pile up too much, to set aside a certain storage tank, usually 3 centimeters on it.
6. In order not to let it rot because of the muggy heat, you can top it after planting it, which can promote it to divide more branches.
7. After planting and topping, you can properly water it, do not pour it violently, or it will wash the surface of the soil out of the pit.
Change the basin of the same size
If it is to change the same size flowerpot, in fact, the steps are similar to the above, as long as in the second step, take off more part of the root, so that you can leave more room for new soil. However, it should be noted that because the roots are removed too much, the ability to absorb water becomes weaker, so it is necessary to prune the upper branches properly and cut off all the yellowing or over-long branches to prevent the loss of water and nutrients.
Matters needing attention
When changing the basin, you need to cut off the blackened or rotten roots and keep the white roots. In addition, when taking off the basin, do not let the basin soil too dry, otherwise it will be easy to pull the root system, it is suggested that you can properly pour some water, it is best to let the basin soil in a wet state to take off the basin.
- Prev
Watering with spoon sugar, the leaves are green and oily, and the slaps are big!
After growing flowers for so long, everyone is looking for more convenient "shortcuts". It would be very convenient if we could add something small to watering the flowers to quench our thirst and fatten them. Amoy rice water, soybean water are rotten street, below these watering flowers, you must know!
- Next
How to make buttercup blossom quickly
For buttercup to bloom quickly, wait until it has three to four leaves, transplant it into a 16 cm pot, change the soil, and wait until frost falls to put it in a low temperature greenhouse, the best temperature is between 10 and 20 degrees. Next appropriate topdressing, and in the early bud appropriate Shubud, cut off the residual flowers.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?