The leaf cuttage of a rubber tree only needs one leaf to return a whole plant to you.

Rubber tree is a famous foliage plant, leaves are evergreen, evergreen, and rubber tree has a unique function of purifying air and dust, can absorb harmful gases in the air, and release oxygen, improve the concentration of negative ions in the air. Is a very good decorative home plant, many flower friends will choose to raise a pot of such plants, rubber tree breeding simple, easy to survive, the following on how rubber trees can reproduce a whole plant with a leaf.

First of all, we should choose rubber trees that have been cultivated for more than one year, select healthy and thick leaves, cut them off with blades attached to the trunk, wash them with water until there is no more emulsion, and then dry the wounds. The material I choose for the cutting bed is perlite, vermiculite is the best cutting bed planting material, but here we use perlite to operate.

Choose a coke bottle, make a simple cutting bed, cut from the side in the bottom and side holes, below with some stones fixed, put the coke bottle on top, this is conducive to drainage, and then put the dried leaves into it, be careful not to forget to water, water once a day.

This cuttage about 14 days, the surface of the leaves looks very fresh, very energetic, and then after 10 days, the leaves have no other changes, then the leaves will take root, the wound tissue has all healed, the condition of the leaves is also very good, small roots will grow, and the roots can be transplanted to the flowerpot when they grow longer. Is it very simple? If you learn it, you can try it yourself.

Rubber tree breeding experience: rubber tree as a bonsai should be placed in a well-ventilated place with sufficient light, indoor to have a certain humidity, if these conditions are not, then rubber tree will appear yellow leaves, hair dry, but also easy to cause diseases and insect pests. These necessary conditions must be met. Rubber trees do not need to be watered frequently, watering should be thoroughly watered, the amount of watering should not be too much, otherwise the roots of the plants will rot, and lead to plant leaves, autumn and winter season to reduce the amount of watering.

The best season for rubber tree propagation is spring and summer, so when cutting rubber trees, pay attention to the time, the best growth temperature is 20℃-25℃, the highest temperature of high temperature resistance can also grow very well, rubber trees are not cold-resistant plants, so northern winter breeding should pay attention to indoor temperature, the lowest temperature is above 5℃ to safely winter, some mottled leaves of rubber trees cold resistance and poor so the lowest temperature in winter needs more than 8℃, The rubber tree will lose its leaves if the temperature remains low. Generally, rubber trees need to be turned over once every two years. Sandy soil with good loose drainage can be selected. Soil and rotten leaf soil in the garden can be selected for configuration.