The florist picks some green apple leaves and soon grows a large pot.

Green pineapple can really be seen everywhere, if you have leisure, you can breed a few more pots, and the following editor introduces how to breed a large pot of green pineapple in a short time.

Experienced flower friends have guessed that cutting propagation, because green pineapple does not have flowers and fruits, naturally can only rely on ramet reproduction, simple and efficient.

1. Ramet in soil culture

1. Prepare the basin soil

(the white is perlite, the black is peat, and the yellow is red jade)

It is best to disinfect, disinfect many methods of soaking potassium permanganate, exposure to the sun or boiling water for five minutes, then stay away from diseases and insects.

2. Pruning branches

The branches of the green apple will have growing points. What you need to do is to cut some strong branches on the green apple. It is better to have air root. I don't know what the air root is. Just take a look at the "1" and "2" roots in the picture below.

3. Cuttings

A growing point of each branch can propagate a plant, each segment of 5 cm, a growing point with leaves is the best, no leaves can barely do (air root is slightly buried in the soil)

4. Insert it into the basin soil

Before inserting into the basin soil, the soil can be watered with a little water, not too wet, slightly moist, each branch is oblique into the basin soil, the leaves are not buried in the soil, the whole flowerpot is full of branches. (if you want to breed a large pot of green pineapple, you must first have green pineapple, or you can cut it at Hua you's house.)

5. Maintenance after cutting

After the cuttings are watered, they should be moved to a shady and ventilated environment, the windowsill or cover-up shade is fine, you can spray a little foggy water on the leaves every day, do not let the basin soil accumulate water, or all previous efforts will be wasted.

6. Waiting for sprouting and rooting

(propagated by the garden owner himself)

In less than two weeks, you can see that new small leaves sprout and begin to take root. You just need to keep the basin soil moist and dry.

7. Points for attention:

The basin of cutting propagation must have a drainage hole, and it is best to put broken tiles or small gravel on the bottom of the basin.

After growing small leaves, you can see a little light, either morning or evening.

2. Hydroponic propagation

1. Cut off the branches

Cut a few segments of green apple branches, which is the same as the above method, but considering that hydroponics need to be soaked in water, you can cut off two growing points, each about 7cm to 10cm long, and the lower leaves can be removed.

2. Hydroponic container

(1 and 2 are their air roots respectively, and hydroponic propagation with air roots will be easy.)

Prepare clean water (keep tap water for 2-3 days, or sun for 1 day, Rain Water, cold boiled water is also OK), put the above treated branches into the water, it is better to have a compartment to discharge green radish branches, do not let the leaves soak in the water.

3. Pay attention to hydroponics

Hydroponic water usually needs to be changed every 3 days, or fresh water is used. After rooting, there is no need to change water. After new leaves grow and the root system grows more than 3 centimeters, it can be cultivated in soil and raised in water all the time.

4. Do you need a nutrient solution?

At the beginning of hydroponic reproduction, it is not recommended to put nutrient solution. It needs to wait for the root system to grow well and then release it. It belongs to promoting growth and can not be relied on. Just give two drops a week, not too much.