MySheen

How to improve the quality of rose flowers?

Published: 2024-12-23 Author: mysheen
Last Updated: 2024/12/23, Rose is generally used in the air layering propagation, can also be used to branch cuttings propagation, and with the sowing propagation is very few, few people have seen the seeds of rose, the following is to introduce the best method of breeding rose success rate....

Rose flowers are generally propagated with air strips, and can also be propagated by branch cuttings, but few of them are propagated by sowing, and few people have ever seen the seeds of Chinese rose. Here is the best way to breed rose.

There are many plants that cannot breed with seeds, such as the common pineapple, which is a tropical fruit that cannot reproduce with seeds and can only reproduce asexually and rely on stem and leaf cuttings so that they can continue to reproduce.

In some perennial warm inventions, rose seeds are difficult to germinate, and people need to create a low-temperature environment to break the dormancy of the seeds, usually in the refrigerator, so as to increase the germination rate. Unless it is used to cultivate new varieties, no one will sow and breed rose flowers.

Most of the rose flowers are propagated by branch cuttings or striping, and the following is air crimping.

The branches of the rose are relatively hard, and it is difficult to pile soil strips into the soil. It is most suitable to choose air striping reproduction. Before preparing for striping reproduction, you should first prepare suitable materials. Such as: soft rope, transparent plastic bags, sharp knives and water moss, water moss can be replaced by some loose soil with good water retention capacity.

Step one:

Select cork branches for ring peeling, as shown in the following image.

The length of ring peeling is generally about twice the diameter of branches, rose branches used for high-pressure propagation is easy to succeed, the vitality of branches is very strong.

After soaking in clear water, the newly bought water moss can be soaked in boiling water for two or three minutes, then squeeze out some of the water and wrap it in a transparent plastic film.

After that, the ring-shaped peeling place is completely wrapped with water moss, and the position of the package is the place where the rose branches take root and sprout, and the upper and lower positions of the ring-cut should be completely wrapped to avoid leaving gaps.

The wrapped water moss should be completely wet. if it is wrapped in soil, it is necessary to keep the soil moist and not completely dry. if it is propagated outdoors, it should be properly shaded above the strip reproduction to avoid exposure and not to bask too much. otherwise, the water will disperse very quickly, which is not conducive to rooting and sprouting.

Be sure to wrap it tightly. If it is tied too loosely, the moisture will be lost too quickly, which is not conducive to rooting and sprouting. The position of ring peeling should not be touched at will, otherwise it is easy to break.

After the package is complete, use a rope to tie up the upper and lower parts of the plastic bag, so that it is done.

If you find that the water moss is dry, to replenish the water in time, you can directly use the pinhole to hit the water.

The picture above shows the state of the air striping after a month, you can see that a lot of roots have grown, and then it can be cut off and re-cut in the loose, fertile and slightly acidic soil.

A long time ago, rose flowers were generally propagated with high branch pressing, but now they can be propagated with branch cuttings, which will affect the health of the mother plant. During high pressure propagation, the position of ring peeling consumes a lot of nutrients for rooting. The branches propagated under high pressure are not 100% successful, but the success rate is still relatively high.

The method of high branch crimping of rose is suitable for spring and autumn, but it is not suitable for high pressure propagation in typhoon season.

Now few people will use high-pressure method to propagate rose, most people use branch cuttage propagation, as long as the control of fungi, the success rate of reproduction is still relatively high.

The success rate of high branch striping propagation is higher than that of cutting propagation, which can be used by beginners if they have no confidence in the propagation of Chinese rose.

This method is also suitable for breeding other flowers, it is still very useful, as long as you try more, you will have a lot of fun.

 
0