Rose pressing method: give the rose a high-altitude flying man.

There are many ways to reproduce rose, of course, cutting is the easiest, Huahua wants to stimulate today, rose has become a "high-altitude flying man", using high-altitude technology to breed, do you know?

High altitude crimping time:

It is generally carried out from May to September, and July to August is the most suitable.

Branch selection

Generally choose the branches with strong and full buds in the middle of the year. Select the ring peeling place 10-15 cm below the branch tip, the width of the peeling is about 0.5CM, the depth does not hurt the wood, generally peel with the tip of the knife, and then use the library method.

Some experienced flower friends split it with bamboo slips and put it on. The second end of the bamboo has to drill a hole for the branches to pass through. The hole can be filled with moist moss or rotten leaf mud.

If there is no bamboo, you can press the strip with a disposable plastic cup, drill a hole in the bottom, burn a hole with a lighter, and then fill the cup with rotten leaf soil, or sawdust, sand and gravel, but don't press it too tightly.

After keeping the soil moist on the inner wall of the tube, after about 30 days of root growth, the bamboo tube can be untied, the bottom can be cut, and the new plant will be planted in a pot for maintenance.

You can also use plastic film, after peeling, spread moss and rotten leaf soil with 6-7CM plastic film, wrap it on the peeled branches, and then tie it tightly with a rope, normally watering, fertilizing, keeping the basin soil moist, and then take off the plastic film and plant the soil into the soil.

The method of high-altitude striping propagation is the most suitable for Hua you's rose breeding method. Some rose or branches that grow too high. I can't bend down. It's more appropriate to use this method. Survive and cut it off. At the same time, the plant height was reduced.