Bonsai technique: a complete record of the high position of Cryptomeria fortunei

High crimping is a breeding technique often used in horticulture. It is easy to operate, and there is an advantage that the roots are radiant. A healthy tree can provide a steady stream of bonsai material. There are too many related materials. Today we will take a look at the process of reproducing Cryptomeria fortunei in a high position. The tree species of Cunninghamia lanceolata grow faster and have soft branches. in fact, I don't think it is suitable to make bonsai. But nothing can stop the bonsai master.

This Cryptomeria fortunei can't see the trunk very well. But the branches are so thin and long that they basically have to be cut off. Before cutting off, if you can make a high bar, breeding some is also regarded as waste utilization.

Choose the right location.

Under the knife, the knife should be quick, and the incision must be cut flat.

Scrape off the cambium.

Find a piece of plastic paper.

The bottom of the plastic sheet is wrapped at the lower end of the incision at a certain distance and tied up.

Stuffed with wet moss.

It's almost stuffed. Tie the water moss tightly with aluminum wire. This is good for root growth.

And tie the top tight.

Observe at any time, if you find that there are already many roots inside, you can consider cutting it off and transplanting it.

After months of waiting, it is time to transplant.

The root system is good, and the effect of whorl is very good.

So I cut it off.

Find a basin and install it. Beautiful