Breeding methods and precautions of asparagus
I. the mode of reproduction
1. Ramet
First, the branch that has been growing for two or three years is generally used to split the plant, remove it from the basin, and then clean up the soil from the root. Its survival rate is very high, as long as the root is not seriously injured.
Second, use some chicken manure as fertilizer, choose soft soil and put some mud from the pond at the bottom of the basin.
Third, after the ramet, water it thoroughly at once, usually wait until the soil is dry before watering, the temperature of the water should be about the same as the temperature.
2. Cuttage
First, if the temperature in this way is too low, its survival rate will not be very high, so it is best to do it in an environment of 20-30 degrees. To choose a bamboo with a lot of branches and leaves, make a small opening in the selected bamboo and coat it with liverworts. Keep it for ten days and keep it humid during this process.
Second, wait until ten days later, the wound will grow a tumor-like knot, and then it can be cut off.
Third, put some soft and moist soil in a cloth bag, then make some small holes in the outside of the cloth bag, and then put the branches in. Put it in the basin, fill it with soil, and it will soon survive.
3. Sowing seeds
First, when its seed is soft, it means it is ripe. You can take it off, wash it with water, then dry it and store it.
Second, wait until early April to plant its seeds in sand, preferably in wooden pots. Put three seeds in each pot. Then cover it with sand, not too thick or too tight.
Third, pour a lot of water on it after planting, and then seal it with plastic wrap to ensure a temperature of about 25 degrees and the soil is moist enough.
II. Points for attention
1. The soil should be breathable enough and the drainage effect should be good enough.
2. don't hurt its roots when you basin it. Change the soil every spring and use a larger basin each time.
3. Water it often, but the dose should not be too large. You can spray water on its leaves. Spray once or twice a day in the heat.
- Prev
The method of changing soil Culture to Water Culture of asparagus
First of all, remove the soil and retain most of the soil on the main root. Then wash its roots, remove the bad roots, and then disinfect them. Choose a container with a larger caliber, insert it and pour water, the water cannot be higher than its root. Then sprinkle its leaves with water to make it moist enough. At the beginning, the water is changed every three days, and after half a month, it becomes once every four or five days.
- Next
What fertilizer is the best for Anthurium andraeanum?
The most commonly used ones are liquid fertilizer, slow-release fertilizer and so on, as well as fertilizers specifically for this plant. As far as nutrition is concerned, it is best to choose the species with balanced nutrition. In terms of the way, choosing the root is the best. However, compared with the type and method, the method is more important. It varies from time to time and from time to time. We should also pay attention to the time, usually from 8: 00 a.m. to 5: 00 p.m. In winter and spring, it can be from 09:00 to 04:00 in the afternoon. In addition, there are some precautions, which will be described below.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?