What if Anthurium andraeanum doesn't bloom?
1. Temperature
(1) the specific reason: the temperature is too low, it is definitely not conducive to flowering. But it's not as high as it gets. If it has passed, it is not conducive to flowering.
(2) solution: therefore, the appropriate temperature range needs to be guaranteed. Generally speaking, it is 15 to 30 degrees. Maximum, not more than 35. The lowest, not less than ten.
2. Lighting
(1) the specific reason: it is similar to the previous aspect. Being in too shady environment, like too strong light, may result in no flowering or less flowering.
(2) solution: scattered light and uniform light are the best. For example, you can put it on the balcony in the east or west. In this way, photosynthesis can be carried out, and the light is not too strong. Furthermore, it can turn its direction over time.
3. Water and fertilizer
(1) specific reason: if these two are not in sufficient supply, it will be very difficult to blossom.
(2) solution: the two can be combined. Fat is relatively more important. Before flowering, you need to use some fertilizer containing more P and K and spray it once every ten days.
4. Ventilation
(1) specific reason: many friends think that ventilation has little to do with flowering, but it is not. Poor ventilation can lead to metabolic disorders.
(2) solution: improving ventilation conditions. At the same time, cut off the over-dense and aging flower branches in time to avoid affecting the effect of ventilation.
5. Diseases and insect pests
(1) specific reasons: if diseases and insects happen to be born during flowering, they may also fail to bloom.
(2) solving measures: there are mainly "root rot", "red spider" and so on. For them, it is mainly prevention. As soon as you find it, deal with it.
- Prev
What if asparagus leaves off?
First of all, it may be the light, the light is too strong. At this point, you need to move it to a cool place and spray some water on the leaves as appropriate. In addition, there is too much water, and the roots rot after the stagnant water. In that case, it is necessary to control the amount of water and loosen the soil. The third is the problem of fertilizer, which is too thick or not rotten. Remove the plant from the pot, remove the fertilizer, rinse with clean water and put it back in. However, there is a special case, that is, the loss of leaves is serious in winter. It may be that they have not been watered for a long time, so they have to be watered properly.
- Next
What about the dry hole in the middle of Anthurium andraeanum leaves?
This situation has a great impact on its appreciation. It is mainly due to the lack of light and has lasted for a long time. The main treatment measures need to be discussed separately. If the broken area is small, you can apply some potion to prevent it from rotting further. Then, put it in a ventilated place. If the area of the hole is large, the rotten leaves need to be cut off to avoid infecting others. Some garlic juice can be sprayed to kill bacteria. At the same time, pay attention to enough light.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?