Post-anthesis treatment of hibiscus flower
1. Pruning residual flowers
The treatment of its withered flowers is necessary and primary, because it will not let it consume nutrients in vain, and it is easier for the next wave of flowers to bloom. In order to cut off the residual flowers, there are skills to learn, we must cut off from its stems and branches, because this can effectively avoid the loss of nutrition, and then blossom will have more nutrition.
Second, sufficient light
Light is necessary, this is a kind of plant that likes light very much, and many people have a misconception about this plant, thinking that it can only open once. In fact, if we put it in a place with strong light, it is easy to let it open again. The general placement is in the light facing south indoors, and it is feasible to put it outside.
III. Timely fertilization
Because there will be a lot of lack of nutrition as soon as it blossoms, we need to replenish it in time, mainly with phosphate and potash fertilizer, and supplemented by nitrogen fertilizer. If you are too lazy to buy part by share, you can buy compound fertilizer. The interval between the first flowering and the second flowering is relatively long, about half a month, so it is basically necessary to apply fertilizer after it has bloomed once.
4. Moisture
Water is also very important, because it likes the humid environment, so we should give it plenty of water, especially in the flowering period, if it blossoms but the water can not keep up, it is likely to cause its buds to fall. So in general, we have to keep its soil in a wet state. Spray water once in the morning and at night, so that it will be better to blossom.
- Prev
Do not forget how to grow
The time is usually from September to January of the following year. Flower soil to choose loose permeability, fertility, nutrition, water permeability is good, and slightly alkaline soil. Seeds should be selected as full as possible, without pests. After the seeds are sown, they need to be covered with a thin layer of soil. Humidity must be guaranteed first. Then there was the temperature. It should be fifteen to twenty degrees. It must not be too high. It should be twenty-five degrees at most. Ventilation should also be noted. After waiting for ten days to half a month, they could sprout. When about five true leaves grow out, they can be planted.
- Next
What kind of soil should be used for hanging orchids?
We can give it soil with rotten leaves and some soil mixed with sand or coal ash, which is superior in terms of fertilizer and air permeability. It is also better to use deciduous soil because it has high nutrients. It would be nice to add some sand to ordinary soil.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?