Cutting method of Tripterygium wilfordii

1. Time

To carry out this operation or to find the right time, generally we are in the end of spring at the beginning of summer to carry out this operation, because this season a lot of conditions are more appropriate.

2, branches

For the selection of branches is also a method, generally we have to choose the semi-lignified branches that grow out of the year, and the length is about 20 cm, we have to immediately put it in a bag with suitable humidity for standby, of course, we had better use wet toilet paper or cloth to wrap its wound.

3. Scrub

We have to clean the cutting utensils, remove some of the residual substances inside, and then wash them clean.

4. Matrix

There are still requirements for the matrix, generally we have to choose more breathable, such as the use of perlite and peat, and then we have to spray it wet, humidity should be moderate, do not need to be particularly wet, generally let it hold into a group after not dispersing is very good, if you can hold it out of water, it is still not good.

5. Cutting

The early preparation is ready, the specific operation is to take the branches out of the plastic bag, then cut off the leaves below it, and then stick some rooting powder on the bottom, of course, this is required according to its use requirements, then we will insert the branches into the medium, pay attention to one point that the leaves cannot touch its edge.

6. Bagging

We have to cover it with a bag, and then put it at about 20 degrees of temperature, and need to be a place of astigmatism, about once or twice a day to open the bag, and then check the moisture content inside, if water shortage can try to spray some water on it.

7. Rooting

Generally, roots can grow in about two weeks. If you want to transplant it, you still need to wait until the root length is about eight centimeters.