It's cheap and easy to raise the top ten succulent plants that explode accidentally.

The meat is so cute.

There are not too many ~

The following ten kinds of succulent plants

If they are not careful, they will show you.

one

Zi Zhi Lianhua

The seed holding lotus flower is mainly propagated by cuttings. during the growing season, pull down the small seedling holding lotus flower and put it on the surface of the soil, and it will take root quickly. of course, the seedling should be a little bigger, so it is easier to succeed. Leaves alone can also reproduce, and when they grow up, they can also take root and grow into new plants if there is enough water on the soil.

two

Ji Xing Beauty

Jixing beauty is often used for sowing, leaf cutting, cutting and ramet propagation. Sowing: from February to May, indoor pot sowing was used, the optimum temperature for germination was 18-21 ℃, and germinated 12-15 days after sowing. Cutting can be carried out all year round, easy to survive, spring and autumn is better, cut the top leaves of compact short branches, length 5-7 cm, inserted into the sand bed, cut soil to keep slightly moist, rooting 10-12 days after cutting. It can also be inserted in one leaf, and the mature and fleshy leaves are scattered on the sand bed and sprayed with water several times. after a few weeks, they take root from the base of the leaves and grow young plants.

three

Thin snow perennial grass

The reproduction of Herba Euphorbiae can be combined with changing pots to split the plants. the method is to separate the tufted plants and plant them separately. Cuttings can also be carried out in the growing season, the length of cuttings is not strict, the soil can take root and survive.

four

Guanyinlian

Guanyinlian is commonly used for ramet propagation. Generally, when the temperature is high in spring and summer every year, the underground tuber plants with dense tillers are divided along the tuber separation place, so that each part has 2-3 plants, and then planted in the pot. At the same time, it is advisable to keep the basin soil moist and pay attention to foliar spray to facilitate the restoration of new plant growth. It can also dig out the underground tuber before the new buds grow in spring, separate the tuber segments, disinfect the wound with plant ash or sulfur powder, wrap it with water moss after slightly drying, or put it in loose soil with ventilation and drainage, so that it can grow adventitious roots and grow new buds.

five

Undead bird

Undead birds (rooting on the ground) are succulent plants of Sedum family, with a wide variety of species, but the breeding methods are basically the same. Undead birds like a warm, moist, sunny and well-ventilated environment. It is best to keep the temperature above 2 degrees in winter to survive the winter safely.

six

Spider silk curly Juan

Spider silk curly Juan commonly used leaf cutting, branch cutting, ramet can reproduce. The spider silk roll silk is easy to grow in groups, and the methods of reproduction include sowing, ramet and beheading. Kites are generally propagated by the ramet method. The soil of the kite is made of peat mixed perlite and cinder, which is about 1:1:1. In order to isolate the contact between the plant and the soil surface, and to make it more breathable, the kite is usually covered with clean river sand with particles, which are 3 to 5 mm in size.

seven

Purple rice grain

The propagation of purple rice grains is relatively simple. The fallen branches can take root by putting them into the soil.

eight

Buddha beads

Buddha beads, also known as pearls, can be propagated by cuttings. Branches and vines are easy to take root and can be cut off in spring and autumn. Half of them are buried in sand or loose soil, keeping them moist but without stagnant water, and they will soon take root for planting.

nine

Jade of the Rainbow

Rainbow jade usually adopts the method of cutting, stem cutting and leaf cutting. Stem insertion can use pruned branches, cut off the growth of 5 cm stem segment, it is best to dry in the shade for 3 to 5 days, wait for the incision to dry and then insert into the seedbed. Leaf cuttage propagation is to remove the complete leaves from the stem (be careful not to damage the leaves) and place them for 3 days before cutting. This method has a large reproduction coefficient and is suitable for mass reproduction, but the forming is slow.

ten

Ji Qiuli

Ji Qiuli is a very easy breed. Healthy, mature and complete leaves can be cut in spring and autumn (winter in the north of the Yangtze River). Slightly tilt or flat leaves on vermiculite, peat or coconut bran, keep a little damp, will soon take root at the base, and grow new buds, when the new buds grow slightly larger, another plant will become a new plant. In addition, the young plants sprouting next to the old ones can also be used for cutting. Before cutting, the cut should be dried, and then the lower stem should be shallowly buried in the sand.