What if the leaves of the rubber tree wilt?
1. Caused by soil replacement
If you've just replaced it and the leaves start. Don't worry, it may be normal. At this time do not let direct sunlight it, and watering a small amount, and then put it in the ventilation, after a short time should be alive. However, there was always a contingency. If it didn't improve for a week, he might not survive.
2. Caused by raw fertilizer or fertilizer concentration
In the process of fertilization, if fertilizer is not used correctly, blindly using raw fertilizer or agricultural fertilizer will burn its roots, making it unable to provide water and nutrients for the leaves, and the leaves will begin to wither. Therefore, when fertilizing at ordinary times, we should dilute it with water and apply it in order to make the plants grow normally.
3, caused by watering
When watering, if you are not careful to pour too much, so that the root system can not be fully absorbed, it is easy to have water left. In this way, the roots are soaked in stagnant water for a long time, which is easy to cause root rot. After root rot, the leaves will wither. At this point we have to reduce watering, and timely replacement of soil, so that the roots can breathe comfortably, then the leaves will be green. However, it is not allowed to water for a long time, which will make the pot soil too dry to meet the most basic water needs of the plant, and the leaves will wither. So when we water, we just need to get the soil a little wet.
- Prev
What about the rotten root of the valley?
Rotten root is a common problem of lily of the valley, how to deal with it? In fact, it is not difficult, first of all, to find the cause, if there is too much water, timely drainage, if too much flower fertilizer, timely neutralization, if the situation is more serious, directly change the basin, cut off the rotten roots, and then disinfect, and then plant into the new flower soil. However, if the situation is so serious that most of the roots are rotten, it can hardly be saved.
- Next
What if the leaves of the rubber tree are curled
The rubber tree is very good-looking, and many flower friends have raised it, but once its leaves are rolled up, it is not very good-looking. What do we do then? First of all, find out the reason and take different treatment methods according to the specific situation: if it is caused by improper amount of water, then replace the correct water replenishment method; if the temperature is too low, then adjust it to 22 ℃-32 ℃; if it is caused by insufficient light, then fill the light in time, if it is caused by soil consolidation, then loosen the soil in time.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?