Propagation methods of Phyllostachys pubescens

1. Rhizome slicing and propagation:

1. The first thing we need to do is to dig out the underground stem of the plant, then clean the mud on the rhizome with clean water, and then cut the stem into blocks with a knife, each with about three or four buds.

two。 To prepare the soil for sprouting, this plant likes rich, slightly acidic, loose and well drained sandy soil. We'd better prepare this kind of soil for it.

3. This plant is very afraid of drought, and it can grow on the edge of the water, not only not afraid of waterlogging but very fond of the wet environment, so we have to pour water on the soil, preferably to the extent that it can spread out of the soil.

4. Then bury the tubers, the spacing of each tuber should be up to 40 centimeters long, because the plant can grow very tall.

Second, cutting propagation:

1. If it is done in this way, it can usually be done at the end of August or the beginning of September, using scissors or inserting it into the water immediately after the branches are cut off. Because this way can not leave the water, so it must be cut and inserted at any time.

two。 In general, the water level on the cutting seedbed is three to five centimeters high, and after about 20 days, it can grow roots.

3. If you are exposed to the ground for planting, you can choose to dig a hole on the edge of the pond or near some low-lying rockery rocks that are prone to stagnant water; if you want to plant in the basin, you can choose a container with an inner diameter of about 50 to 60 centimeters, preferably the kind that will not leak, and always water it after planting, and be sure to keep the soil moist and shallow water level.

Matters needing attention

1. When it grows out, raise the water temperature at the right time, because it likes to be warm and afraid of the cold.

two。 It is necessary to remove the surrounding weeds in time so that the plants can absorb nutrients.

3. If the light is too strong, shade it properly.