MySheen

The breeding method of the latest Happiness Tree

Published: 2024-11-23 Author: mysheen
Last Updated: 2024/11/23, The scientific name of Happiness Tree is Bean Tree, which is hot, humid and sunny. It is resistant to high temperature, cold, moist and dry. It is suitable for cultivation to use loam and sandy loam with loose, fertile, well drained and rich organic matter, flowering from May to September and fruiting from October to December.

Happiness tree scientific name kidney bean tree, sex like high temperature and humidity, sunshine foot environment, high temperature resistance, cold intolerance, appropriate wet, avoid dry, cultivation should use loose fertile, good drainage, rich in organic matter loam and sandy loam, flowering May to September, fruit period October to December, let's take a look at the reproduction method of happiness tree!

seed reproduction

At the end of December, when the capsule is close to dehiscence and the seeds are fully mature, the elongated capsule is harvested, the winged seed grains are detached after drying, the membranous seed wing fragments are removed after kneading, and the dry storage is carried out until the next spring. It can also be soaked for 2 to 3 hours and then mixed in wet sand, thinly spread in a large plastic basin in the shed, keep the seed and sand moist, check frequently to prevent mildew, and sow on the ground after the seed germination. The dried seeds are soaked for 3 to 4 hours from March to April, then taken out and spread slightly, mixed with sand and sprinkled on the prepared seedbed, lightly covered with thin soil, covered with thin film to keep moisture, removed after the seeds emerge, and shaded by a sparse shade. When it grows 2 to 3 true leaves, it can be transplanted with soil mass, or when it grows 4 to 5 large leaves, it can be planted in pots or bags, strengthen water and fertilizer management, and can be sold as commercial seedlings in the same year.

cutting propagation

From March to April, when the ambient temperature reaches about 15 DEG C, lignified branches of 1 to 2 years old are cut, about 15 cm to 20 cm in length, all leaves are deleted, and the lower incision is preferably located at 0.5 cm below the node, and the cuttings are cut on a sandy soil seedbed, and the cutting depth is about 1/3 to 1/2 of the ear length. During the period of its undercutting healing and rooting, water should be sprayed to keep the seedbed moist. After it grows a complete root system, it can be transplanted to the pot with soil mass, preferably 2 to 3 plants, which can be formed and sold as soon as possible.

layering propagation

May be in March to April, in the 2-year-old strong branches or stems under the node, for ring peeling, peeling width is generally 2 to 3 times the diameter of the stem by layering. Tie a 15 cm x 20 cm piece of plastic film under the girdling opening. Use clean moist peat soil or sandy loam soil to hold a ball of soil 8 cm to 10 cm in diameter at the girdling site. Next, wrap the soil in plastic film, leave a water inlet at the top, and tie it against the thick trunk to prevent it from drooping and breaking by the wind. At the end of autumn, after the girdling mouth grows a better root system, it will be cut off from the mother plant and planted separately in the pot.

 
0