The latest planting method of snake skin fruit

Snake skin fruit is mainly produced in Indonesia, because the climate and other conditions there are the most suitable for the growth of snake skin fruit, while the snake skin fruit on the Qi market is imported, so the price is very expensive, and it is not necessarily available. Its skin is very similar to snake skin, but after peeling, it shows a white petal shape, which is somewhat similar to garlic, and has the effect of developing human brain memory, but there will be side effects if you can't eat more. Today, the editor has brought you the planting method of snake skin fruit. I hope you can like it.

1. Planting conditions

The requirements of planting conditions in snake skin fruit field are relatively strict. Snake skin fruit is a kind of plant that likes light, heat and humidity, so the planting conditions must be high temperature and humidity. Usually, it is best that the average temperature of the whole year can reach 22 degrees or above, and the lowest temperature can not be lower than 18 degrees, otherwise it can not grow normally. Secondly, there must be at least eight to ten hours of light every day. The humidity in the air should be kept at about 80%, and then after the planting site is selected, the soil preparation is generally carried out by means of full reclamation, and the planting holes are dug for 50 cm in length, width and height, and finally the seeds can be sown.

2. Scientific planting

There are two methods of planting snake skin fruit, which are seed sowing and tiller strip planting, seed planting is as long as the seed is placed in a dug hole, then covered with soil, and finally watered. On the other hand, the planting of sprouting tiller strips is to choose the sturdy sprouting tiller strips of snake skin fruit, put them in a container for cultivation, take them out after 60 days, separate and treat those with different rhizomes, and then plant them.

3. Field management

The field management of snake skin fruit is mainly water management, heat management, nutrient management and pollination tree collocation management. We have selected the area close to the water source before planting, and we choose to plant in areas with high rainfall and enough heat. At the same time, we need to install hygrometers and thermometers in the forest, so that humidity and temperature can be managed at the same time. Once it is found that the humidity and temperature are not up to standard, it should be regulated in time. Secondly, it is necessary to measure the fertilizer at least three times a year, so that the nutrients in the soil can make the snake skin fruit grow normally, and when planting, we should pay attention to the proportion of male and female trees, so that the fruit yield will be high. after rent, it is necessary to control the growth of branches and leaves of snake skin seedlings, not to grow too dense.

4. Artificial pollination

The probability of successful natural pollination of snake skin fruit is not very high, so the annual yield is very low, so when snake skin fruit blossoms, we had better use artificial pollination to pollinate, so as to increase the yield of snake skin fruit. first of all, we need to collect the pollen from the male flower, then apply the pollen to the female flower with a special pollination brush, and finally protect it with a layer of plastic film. In this way the success rate of pollination will be higher.

5. Pest control

According to the instructions of the relevant growers, the resistance of snakeskin fruit trees is very strong, so there are basically no diseases and insect pests all the year round, but occasionally beetle pests appear, which mainly harm the roots of snake skin fruit seedlings and cause plant death in serious cases. So to carry out timely prevention and control, beetles can be used to irrigate roots, at the same time, ordinary growers have a soil method. Is to use the rabbit urine to irrigate, this kind of control effect is also very good.