The Propagation method of Euphorbia angustifolia

1. Sowing and reproduction

If this kind of plant is propagated in this way, it is usually chosen on rainy or cloudy days. We can prepare the seedbed, which generally needs to be in a relatively flat place, and requires the soil to be relatively loose, so that the soil can be sown after it is wet.

Cut the stems and leaves that grow vigorously into small segments with a length of 3 to 4 centimeters, and then spread them evenly on the prepared seedbed. The spacing between the stems and leaves of the sowing should be 1 cm wide, and then you can cover it with a thin layer of soil. Finally, you can sprinkle water on it. To keep the soil humid, it will grow roots in about a week, and then it can enter the daily management.

two。 Cuttage propagation

If this kind of plant is cuttage propagation, it is suitable to choose in summer or autumn. Choose the seedbed of cutting, generally choose the place where the terrain is relatively flat, and require the soil to be loose. Then we can water the soil layer, mix the water and soil evenly with a rake, and then cut trenches with a spacing of 10 to 15 centimeters wide. then the stems and leaves that grow vigorously are cut into small segments with scissors at a height of 10 centimeters.

Cut the stems and leaves in the ditch and cover them with soil, about 3 to 4 centimeters. After leveling the soil, you can irrigate it with a lot of water, once every three days, about two or three times.

3. Ramet propagation

If the plant uses ramets, it is necessary to cut its leaves into branches 6 to 7 centimeters long, then sprinkle them evenly on the soil, hoe the soil surface gently with a rake, so that its stem nodes can be buried in the soil, and finally spray water on it twice.