Planting technology of pomegranate tree

Before planting pomegranate trees, be sure to select varieties and soil. Varieties generally choose seedlings with round leaves, sandy soil with sufficient fertility, and then plant pomegranate seedlings into the soil, pour them into the soil, apply sufficient basic fertilizer, and control the temperature at 15-25 degrees. Just put it in the sunny place. When planting seedlings, the density should be suitable, and the general plant row spacing of 4-8 meters is the best. when it comes to flowering, the fruit setting rate can be increased by applying appropriate amount of fertilizer.

Points for attention in planting pomegranate trees:

1. Variety selection

At present, many pomegranate trees sold on the market only blossom but do not bear fruit, or even do not even blossom, so we must be very careful when choosing tree species. We carefully observe the leaves of the saplings. Generally, the pomegranate leaves will be a little round, while the unfruitful leaves will be pointed, and the unfruitful leaves will be relatively good-looking.

2. Temperature and light

The growth of pomegranate has strict requirements on light and temperature, it needs sufficient light, especially during the period of pomegranate flowering and fruiting, the more light, the more flowers will bloom, and the fruit setting rate will be higher. At the same time, the temperature suitable for pomegranate growth is between 15 and 25 degrees Celsius, too low will frostbite fruit trees, and too high will burn fruit trees, so the temperature should be regulated in winter and hot summer. Finally, we sometimes eat very sour pomegranates, which is due to lack of light and temperature, so scientific temperature and light can also improve the quality of pomegranates.

3. Fertilizer and water management

In the process of pomegranate growth, pomegranate trees generally need to be watered when planting pomegranate, once thoroughly watered to supply the water needed for growth, that is, when the pomegranate is relatively dry. Pomegranate should have enough basic fertilizer when it is planted, and the second fertilization is during the period of pomegranate flowering, so as to maximize the rate of fruit setting and fruiting, and the pomegranate will be sweet at the same time. Try not to pour too much water during the fruit growth, otherwise the pomegranate will be tasteless and particularly light.

4. Scientific planting density

The planting of pomegranate trees should pay special attention to the planting density, we try our best not to grow too high, because this will increase the difficulty and work of harvesting, so in the growth process of pomegranate trees, we need to prune the branches and leaves of pomegranate trees, first of all, we need to cut off the redundant and poorly grown branches and leaves at the bottom, and the second is to cut off part of the longer branches and leaves in order to control the density. Generally speaking, the best density of pomegranate planting is that each pomegranate tree is four to five meters apart.

5. Disease control

The pomegranate tree pests are mainly beetles and birds, they will eat the pomegranate slowly from the outside, if there is no timely control, there will be no pulp in the pomegranate when harvested, only the poop they excreted, so the corresponding prevention and control work must be done during the flowering and fruiting period.

The above is the introduction of pomegranate planting technology. I hope it will be helpful to you.