Culture methods of all kinds of flowers

Scorching method: after scorching the end of the flower branch on the candle flame, immediately soak it in alcohol for one minute, and then rinse it in clean water; scalding method: soak the base of the flower branch in boiling water for about ten seconds to block the incision and prevent the juice from overflowing from the flower branch tissue. Deep water first aid: when the flowers hang their heads, they can cut off a short section at the end of the flower branches and put them in a container full of cold water, leaving only the flower heads on the surface of the water. After one or two hours, the flowers will wake up.

Culture methods of all kinds of flowers

1. Scorching method: after scorching the end of the flower branch on the candle flame, immediately soak it in alcohol for one minute, and then rinse it in clean water. Hydrangea, cloves, wood incense, peony, rose, chrysanthemum, ivory red and so on can be treated with this method.

2. Dipping and scalding method: soak the base of the flower branch in boiling water for about ten seconds to block the incision and prevent the juice from overflowing in the flower branch tissue.

3. Deep-water first aid: when the flowers hang their heads, they can cut off a short section at the end of the branches and put them in a container full of cold water. Only the heads of the flowers are exposed on the surface of the water. After one or two hours, the branches will wake up. This method is suitable for both herbaceous and woody flowers.

4. the method of using fresh-keeping agent: adding an appropriate amount of fresh-keeping agent to the container of flower arrangement can prolong the time of flower arrangement. In addition, inserting Gladiolus orchid with 1/3000 aspirin solution or 1/2000 potassium permanganate solution can prolong the flowering period for three to five days, adding appropriate amount of boric acid, sulfur, carbonic acid, salicylic acid, salt, vitamins, etc., can prolong the flowering period.

5, enlarge the incision method: generally cut the base of the flower branch obliquely; or cut the base into two to four parts and embed the small stone particles to open the crack; it can also hammer the base to expand the water absorption. Among them, oblique cutting is the most commonly used, and the latter two are mainly used in woody flowers, such as magnolia, hydrangea, cloves and wisteria.

6. Sterilization: put alcohol, KMnO4, camphor, boric acid, citric acid, salt and alum in water. Only water does not rot, plants can absorb water and keep fresh. Note: must be mixed into a solution before use, do not dissolve directly into the water, pay attention to the concentration of salt should not be too high.

7. Nutrition: after the flowers are cut from the mother, they lose the source of nutrition, and all kinds of nutrients such as sugar, beer, aspirin, vitamin C and so on can be added.

8, spray body, injection method: for many flowers with hollow stems, the flower feet can be forcibly irrigated under the faucet.

Note:

1. Keep the water clean: change the water every day and cut the roots to reveal new stubble every day. Remove the extra leaves where you soak in the water.

two。 Stay away from heating agent _ ethylene: stay away from vegetables and fruits, as they release a lot of ethylene, causing flowers to decay, and at the same time, the fallen flowers and fruits are cleaned up in time.

3. Fresh-keeping temperature: about 5 degrees for ordinary flowers and 10-12 degrees for tropical flowers.

4. Location: away from direct sunlight in summer and away from tuyere in winter.