MySheen

Planting method of sprout vegetable of red bean

Published: 2024-12-23 Author: mysheen
Last Updated: 2024/12/23, Prepare some full and brightly colored red bean seeds, soak them in 20 degrees water for 16-24 hours, change the water four times, then remove them and wrap them in gauze and put them in a cool place to sprout. After germination, spread it evenly on the seedling plate and cover it with a layer of tissue paper.

Prepare some full and brightly colored red bean seeds, soak them in 20 degrees water for 16-24 hours, change the water four times, then remove them and wrap them in gauze and put them in a cool place to sprout. After sprouting, spread it evenly on the seedling plate, cover it with a layer of tissue paper, and put it in a cool place. When the sprouts grow to about 15cm, they can be cut off and eaten. During the breeding period, water should be drenched every morning and evening, but do not accumulate water.

Detailed planting methods of red bean sprouts:

1. Planting equipment

Use bricks to make planting grooves 100-120 cm wide and 20 cm deep in dark, shaded rooms or protected areas. Cover the bottom of the trough with plastic film and punch holes in the film at intervals to drain excess water. Vermiculite, perlite and river sand are used as substrates.

2. Seed selection

Select new seeds with full grains, bright color, navel white and germination rate of more than 95%. Remove not full, broken, worm-eaten beans and their impurities, rinse with clean water, rinse the shrunken grains, and wash the seeds.

3. Diffuse planting and budding

The seeds were immersed in 20 ℃ of water for 16-24 hours, and the water was changed 4 times. After soaking the seeds, wash away the mucus and dirt, wrap them with a wet cloth and accelerate germination. When the seeds are white, they can be cultivated.

4. Cultivate

The thickness of the matrix is 10 cm and the bottom water is thoroughly watered. Then sow the budding seeds on it, sowing about 2 kilograms per square meter, covered with a substrate 05 centimeters thick. Splash water with a thin-eyed spray can, then cover with plastic film. Generally, the seedlings are not watered before emergence. Two days later, the red bean sprouts eject the matrix, that is, remove the film.

5. Planting management

The temperature should be kept at 16 ℃-30 ℃. Water 2-3 times a day. Water should be watered thoroughly without stagnant water. Keep the air in the place fresh.

6. Harvest

When the sprouts of red bean are 15 cm high, the first pair of true leaves are not fully unfolded, and the tissue is tender and non-fibrotic, cut off along the base of the stem.

The above is the introduction of the planting methods of red bean sprouts and seedlings. I hope it will be helpful to everyone.

 
0