MySheen

How does succulent Euphorbia pullulata reproduce

Published: 2024-11-22 Author: mysheen
Last Updated: 2024/11/22, Succulent brocade star, also known as red rabbit ear and cat ear, is a kind of succulent plant with fine hairs on its leaves. It will produce orange-red flowers in winter or early spring, which is very good-looking. How does succulent Jinhuang star breed? 1. Branch cutting propagation. 1. Branch cutting time: August-October.

Succulent caryophyllum, also known as red rabbit ear and cat ear, is a kind of succulent plant with fine hairs on its leaves. It will produce orange-red flowers in winter or early spring, which is very good-looking. How does it reproduce?

I. Branch cuttage propagation

The main results are as follows: 1. Branch planting time: August-October.

2. Specific methods:

(1) Branch selection: on the Jinjiang plant, select the top branch with strong growth and cut it into about 10 cm for cuttings. After cutting, remove the lower leaves of the cuttings and place them in a cool place to dry for 1-2 days.

(2) Pool soil selection: after the cuttings are selected, you have to choose a good pot of soil. General branch soil needs to be breathable, good drainage, we can use: rotten leaf soil, coarse sand according to the proportion of 1:1 mixed soil, on the basin after spraying a little water, to keep the basin soil slightly wet.

(3) Branch cuttings start: do the above preparatory work, Jinjiangxing branch cuttings can officially start. The cuttings will be inserted directly into the basin soil to maintain the slightly wet state of the basin soil, which will generally take root in about 10 days.

(2) Leaf cutting propagation

1. Leaf insertion time: it can be carried out in both spring and autumn.

2. Specific methods:

The main results are as follows: (1) the thick and complete leaves of Euphorbia angustifolia were selected and placed in a ventilated place to dry.

(2) prepare sandy soil and water thoroughly to keep the basin soil moist.

(3) the dried leaves are laid flat on the surface of the basin soil and maintained in a cool place, and the roots usually grow after 2 days.

3. Beheading and breeding

1. Prepare tools

Before beheading it, the tools to be used must be prepared. What we need is clean aquaculture containers and a knife or beauty knife or other tool sharp enough to cut quickly.

2. Beheading position

Before cutting or cutting, you need to find a good position. Generally speaking, if we want to cut the thin stems of already overgrown plants, we should choose to start near the top, and do not cut off the long roots.

On the other hand, if we choose plants with thicker stems and mostly leaves growing at the roots, we have to cut them off near the roots. When cutting, it is best to follow the principle of fast and smooth incision as far as possible.

3. The drying of plants

For the plants that have been cut, we can dry them first. For the cut part, we do not rush to plant, we should first remove the leaves too close to the cut, and then put it in a dark place to dry.

It is important to note that when drying, the incision should not be stained with water or dust. what we need to do is to wait for the incision to dry and then contract by ourselves. the drying time is generally determined according to the size of the cut in the stem. And the cut part can not be placed directly under the bright light, it is best to put it in a dark place.

4. Hairy root transplanting

We can prepare some empty bottles or cups, put the right amount of water in it, and then put the cut part at the mouth of the bottle.

We must be careful not to let the wound come into direct contact with the water, so we should control the height of the water level, preferably 5-6 mm between the water surface and the wound. In this way, we can avoid contact with the wound and dust, and increase the humidity, and when the plant takes root, we can move it into the pot.

 
0